KTI Networks KSD-103-A Series Manuale Utente

Industrial 3-Port Fast Ethernet Media Converter Switches KSD-103-A series KSD-103-B series Installation Guide 1/20 DOC.081111

10/20 2. Installation 2.1 Unpacking Check that the following components have been included:  Information CD  The device unit  DIN-rail mounting br

label. If you are not sure of the type of power source required, consult your service provider or local power company. 2.3 DIN-Rail Mounting In the p

The final mechanical dimensions after installing DIN rail mounting bracket are: 2.4 Panel Mounting The product is provided with an optional bracket

2.5 Applying Power The power specifications of the device are: Operating Voltage +7 ~ +50VDC Power Consumption 4W max. @+50VDC Using Terminal Bl

If cascading the power to next device is needed, install the power wires and plug for another switch. Then, use DC2 contacts. Note: Only up to four

Use the provided 2P terminal plug for signal wiring and plug into the PF+/- contacts. Normal PF+ and PF- contacts shorted Relay Output Indication Al

3. Making LAN Connections 3.1 Making Copper Port (RJ-45) Connections The copper ports support the following connection types and distances: Network

3.3 LED Indication KSD-103-A KSD-103-B LED Function State Interpretation PWR Power status ON The power is

4. Applications 4.1 Application in Industrial Networks The following figure illustrates an application example in an industrial network. Four devices

19/20 5. Appendix 5.1 Model Definition KSD-103-A Model Ext. FX Connector Cable Ref. Distance Operating Temperature -T Duplex ST MMF 2km -10 ~

(C) 2008 KTI Networks Inc. All rights reserved. No part of this documentation may be reproduced in any form or by any means or used to make any direct

20/20 5.2 Optical Specifications KSD-103-A Model Ext. FX Port Wavelength TX Power Sensitivity RX Max. Power-T FX 1310nm -19 ~ -14dBm -31dBm -

3/20 The information contained in this document is subject to change without prior notice. Copyright (C) All Rights Reserved. TRADEMARKS Ethernet is

4/20 Table of Contents 1. Introduction ...

1. Introduction The industrial rated KSD-103 Fast Ethernet switch series supports three switching-base segment communications and benefit the followi

 High and wide operating Temperature  Power input interface: Industrial screw terminal block and DC power jack for external commercial power adapte

KSD-103-B 1.3 Specifications Copper Ports Compliance IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX Connectors Shielded RJ-45 jacks Pin assignments

8/20 Forwarding & filtering Non-blocking, full wire speed Switching technology Store and forward Maximum packet length 1536 bytes max. Flow con

9/20 Certificate FCC Part 15 Class B CE/EMC EMI EN50081-1 Class B EMS EN55024 CE/LVD Safety EN 60950 EN 50081-1/1992 : EN55022