KTI Networks KC-300D-SL2A Guida di Installazione

-1-10/100BASE-TX TO 100BASE-FXMEDIA CONVERTERSKC-300D SeriesInstallation GuideDOC.111122-KC-300D

-10-1.3 Optical SpecificationsThe media converter series provides the following fiber options:Duplex Fiber SeriesModel Port Fiber Wavelength Tx Powe

-11-1.4 Special FunctionsAuto MDI/MDI-X FunctionThis function allows the TP port to auto-detect the twisted-pair signalsand adapts itself to form a va

-12-Link Fault Pass Through FunctionWhen this function is enabled, a link fault detected on the TP port willforce a link down on the FX port. Similarl

-13-2. Installation2.1 UnpackingCheck that the following components have been included:• Installation guide (or contained in the product CD)• 10/100 M

-14-2.3 Applying PowerBefore you begin the installation, check the AC voltage of your area. TheAC power adapter which is used to supply the DC power f

-15-2.4 Making TP Port ConnectionTP port is featured to support connection to :• Auto-negotiation devices• Auto-negotiation incapable 10BASE-T devices

-16-2.5 Making FX Port ConnectionFX port operates on 100Mbps and full duplex (factory default). A varietyof fiber options is provided as follows:Duple

-17-Single Fiber Bi-Di WDM SeriesModel Connector Wavelength Fiber Ref. Distance300D-W3515 Bi-Di SC Tx 1310nm Single SMF 15 - 20kmRx 1550nm300D-W53

-18-2.6 LED IndicatorsLink Fault Pass Through Function is disabledLED Display Status InterpretationPWR Power status On Power onOff Power offTP LINK TP

-19-3. Optional Configuration SettingsThe media converter provides additional configuration settings whichare user-inaccessible. The settings are buil

-2-(C) 2003 KTI Networks Inc. All rights reserved. No part of this documen-tation may be reproduced in any form or by any means or used to makeany dir

-20-3.1.1 Forwarding Mode Setting JP1The following table lists the forward method used in different TP to FXconversions:JP1 Setting TP port to/from FX

-21-3.1.2 802.3x Function Setting JP2IEEE 802.3x function is the flow control method used for full duplex op-eration on TP port and FX port under stor

-3-The information contained in this document is subject to change withoutprior notice. Copyright (C) All Rights Reserved.TRADEMARKSEthernet is a regi

-4-Table of Contents1. Introduction... 51.1 Key Features ...

-5-1. IntroductionThe 10/100BASE-TX to 100BASE-FX media converter series provides amedia conversion allowing high-speed integration of fiber optic and

-6-1.2 SpecificationsTwisted-Pair Interface (TP Port)Connector Shielded RJ-45Pin Assignments Auto MDI/MDI-X detectionSignal Compliance IEEE 802.3 10BA

-7-Fiber Optic Interface (FX Port)Signal Compliance IEEE 802.3u 100BASE-FXConnector SC, ST, MT-RJ, VF-45, LC or Single SCData Speed 100MbpsDuplex Mode

-8-LED IndicatorsLED DISPLAY STATE INTERPRETATIONPWR Power status ON Power onOFF Power offTP LINK TP port link status ON Link up and no trafficOFF Lin

-9-Basic InformationForwarding Throughput Full wire speed at 100M full duplex10Mbps - 14,880 pps at 64-byte packets100Mbps - 148,800pps at 64-byte pac