KTI Networks KG-500F Guida di Installazione

1Installation Guide1000Base-X Gigabit EthernetPCI Adapter with SFP SupportKG-500F seriesDOC.070607-KG-500F-K

10Connecting to the NetworkThe rear bracket of the PCI adapter contains two fiber connectors.The TX connector is used for transmission and the RX is u

11Network Driver InstallationAfter making the connection to the network, you must install theadapter network driver in order to connect the network ad

12LED IndicatorsThe adapter has three LEDs. The interpretations of the LEDs are:LINK LED indicates an active 1000Mbps connection is established.On : G

2The information contained in this document is subject to changewithout prior notice. Copyright (C) All Rights Reserved.TRADEMARKSAll brand names are

3CISPR 22 Class BThis device complies with EMC directive of the European Commu-nity and meets or exceeds the following technical standard: EN 55022- L

4IntroductionThe 1000BASE-X Gigabit Ethernet PCI Adapter is a 32-bit LANadapter for use in personal computers with PCI computer bus slots.This adapter

5SpecificationsStandards IEEE 802.3z 1000Base-SX/LXNetwork Port SFP for 1000Mbps mini-GBIC fiber transceiverHost Interface 32-bit 33/66Mhz PCI Rev.2.

6Board ComponentsThe figures show the major components on the adapters with PCIstandard bracket and PCI low-profile bracket.Adapter with PCI standard

7Adapter with PCI low-profile bracketNo. Components Description1 LINK LED This LED lights when thefiber connection is established.2 SFP LED This LED l

8Installing the AdapterBefore installing the adapter, you need the following:• A computer system that is compliant with the PCI specifica-tions versio

9Installing Mini-GBIC TransceiverA typical mini-GBIC SFP transceiver is shown as follows:To install a fiber transceiver into the SFP slot, the steps a